Selecting The Correct Position; Connecting And Testing The Radio Receiver - Favero Electronics FS2 Manual De Uso

4.1.

Selecting the correct position

Even though the type of radio transmission used is very reliable and the communication distance outdoors is
500m, it is advised that for indoor environments, and in the presence of metal structures, the receiver is installed
in a position that meets the following requirements:
• there are no visible obstacles between the Radio Receiver and the Command Console;
• there are not a lot of metal walls nearby;
• the Radio Receiver is easily accessible.
4.2. Installing on wall
1) Make two holes with a diameter of 6mm each in the wall (Fig. 4.1).
2) After inserting the dowels, align the Receiver and attach it to the wall by inserting and tightening the screws.
Note that the protection dome of the antenna must be in a vertical position.
(1) Screws, (2) Dowels, (3) Holes
Fig. 4.1: Detail of installation on wall
4.3. Installing on the 24 seconds shot clock scoreboard
The various FS-24s scoreboard models displaying 24 second shot clocks require that the Radio Receiver be
installed directly on the scoreboard's rear panel (Fig. 4.2) by using the screws provided.
5. C
ONNECTING AND TESTING THE
Once the Radio Receiver has been installed, you can
proceed with connecting the electrical power supply and
the serial data cables.
5.1. Connecting the Radio Receiver
1) Make sure you have disconnected the power supply
by turning off the power switch.
2) Insert the power cord plug into the wall socket (see
chapter 2 and Fig. 5.1).
3) Connect the electronic scoreboards to the Radio
Receiver via the serial data cables.
5.2. Procedure of Associating the Radio Receiver
If you have bought the Radio Receiver together with the
control console, it will be delivered already configured
for the correct wireless communication. In this case
pass to paragraph 5.3.
F E S
AVERO LECTRONICS RL
(1) Screws
R R
ADIO ECEIVER
(1) Serial data cables, (2) Power supply cord (3) Hole for observing
internal LED.
5 / 36
Fig. 4.2: Installation on FS-24s scoreboard
Fig. 5.1: Connecting the scoreboards
00265-M01-04 - FS2 Radio Receiver Installation Manual
ENGLISH