Selecting The Correct Position; Connecting And Testing The Radio Receiver - Favero Electronics FOS2 Manual De Uso

ENGLISH
2.1.

Selecting the correct position

Even though the type of radio transmission used is very reliable and the communication distance outdoors is
500m, in the presence of metal structures, the receiver should be installed in a position that meets the following
requirements:
• there are no visible obstacles between the Radio Receiver and the command Console;
• there are not a lot of metal walls nearby;
• the Radio Receiver is easily accessible.
2.2. Mounting
Mounting the Radio Receiver is only necessary if
it is purchased after the scoreboard has been
installed. Otherwise, when both are purchased
simultaneously, the Radio Receiver will come
joined to the right-hand (rear view) vertical
bracket with 'Ω' profile. The correct position can
be seen in Fig. 2.1.
1) From the vertical bracket with 'Ω' profile,
located to the right of the scoreboard (rear
view), remove the closing nut and washer of
the top M8x20 fastening screw (Fig. 2.2).
2) Align the support bracket of the receiver to
the 2 holes on the 'Ω' profile bracket as in Fig.
2.2, and lock it in place with the M8x20
screws and relative washers and nuts.
3) Fasten the cable entry conduit to allow for the passage of the cable along the 'Ω' profile bracket of the
Scoreboard as in Fig. 2.2.
4) Thread the cable of the Radio Receiver into the cable entry conduits found on the support structure until it
reaches the power supply module (labeled "
(1) Radio Receiver
(2) Horizontal bracket with 'Z' profile
(3) Cable entry conduit of the Radio Receiver
(4) Vertical bracket with 'Ω' profile
(5) M8 nut
(6) Elastic washer
(7) M8x20 screw
(8) Self-tapping screw
3. C
ONNECTING AND TESTING THE
After installing the Radio Receiver, you may connect the power supply and data cable.
3.1. Connecting the Radio Receiver
1) Make sure you have disconnected the power supply of the scoreboard by turning off the power switch.
2) Connect the power supply and data cable into the connector of the H
the "
POWER SUPPLY
00302-M01-03-ML - FOS2 Radio Receiver Installation Manual
POWER SUPPLY
Fig. 2.2: Detail of mounting procedure
R R
ADIO ECEIVER
" module of the scoreboard, as described in chapter 3.3 of the Scoreboard Installation
(1) Radio Receiver.
Fig. 2.1: Position of the Radio Receiver
").
UB
4 / 26
+24V board labeled 'RR', located inside
F
AVERO
E
LECTRONICS SRL