Configuration Dip-Switches; Signaling Leds; Connection Type Indication - Favero Electronics FS2 Manual De Uso

In this case, the cable coming from the console must be inserted in the connector IN/OUT; therefore, only 2 cable
outputs OUT will be available for the connection to the scoreboards.
7. C
ONFIGURATION
The configuration dip-switches are present on the internal electronic card which can be reached opening the
Radio Receiver case.
SW1
SW2
SW3
SW4
8. S LED
IGNALING
The Radio Receiver contains a red LED which can be checked through the hole provided for this use (see Fig.
5.1). It provides the following indications:
• off: no power supply;
• on: there is power supply but no data are received from the console;
• fast blinking (5 times per second): data are received by wireless communication (with FS1 or FS2 protocols);
• slow blinking (1 time per second): data are received with wired communication.
9. C T
ONNECTION
The type of communication currently used by the scoreboard is indicated when the device is switched on and
each time the connection is changed by means of codes (letters and numbers) displayed on the score digits of the
connected scoreboards.
Code on the scores
F2 NN
F1 NN
CA bL
F E S
AVERO LECTRONICS RL
D -
IP SWITCHES
The radio communication is performed with FS1 protocol.
OFF
Note: Console-320 can be used only with FS1 protocol.
The radio communication is performed with FS2 protocol.
ON
Note: use the FS2 protocol with Console-700.
OFF The IN/OUT connector is a data output to the scoreboards.
ON The IN/OUT connector is a data input from a control console.
The RL1 relay controls the activation of the red illuminated frame.
OFF
The RL1 relay controls the activation of the yellow illuminated frame.
OFF
This function is available only with Console-700.
ON The RL1 relay controls the horn which indicates the end of game time.
OFF The RL2 relay controls the horn which indicates the end of shot-clock time.
OFF The RL1 relay controls the horn which indicates the end of shot-clock time.
ON The RL2 relay controls the horn which indicates the end of game time.
The RL1 relay controls the electrical load which signals both the end of game
ON
time and shot-clock time.
ON
The RL2 relay is always off.
S
I
YPE NDICATION
Radio with FS2 protocol, NN indicates the console number
Radio with FS1 protocol, NN indicates the radio channel
Serial cable
Type of connection
7 / 36 00265-M01-04 - FS2 Radio Receiver Installation Manual
ENGLISH