Configuration Dip-Switches; Signaling Leds - Favero Electronics FOS2 Manual De Uso

Manual.
3.2. Procedure of Associating the Radio Receiver
If you have bought the Radio Receiver together with the control console, it will be delivered already configured for
the correct wireless communication. In this case pass to paragraph 3.3.
If you have bought the Radio Receiver without the control console, it will be necessary to carry out the association
procedure for the wireless communication. Proceed as indicated below:
• Switch on the Command Console and only the Radio Receiver (or Receivers) that should be linked, making
sure that no other Consoles are turned on.
• If there are other Radio Receivers linked/connected to other Consoles in the near vicinity, make sure to check
that they are turned off so as to avoid interference in the linking procedure.
The association procedure is different depending on the type of console used.
If you use Console-700:
• Configure the Radio Receiver with FS2 radio protocol, positioning the microswitch SW1=ON, as indicated in
chapter 4.
• Carry out the association procedure described in Console-700 manual, chapter 2.5.1, paragraph "B)
Association procedure for radio communication through FS2 protocol."
If you use the Console-320 :
• Configure the Radio Receiver with FS1 radio protocol, positioning the microswitch SW1=ON as indicated in
chapter 4.
• On the Console press the buttons
heading "Yes", and then wait for circa 1 minute until it automatically returns to "No".
At this point the Radio Receiver has been linked to the Command Console and will start sending data that it has
received to the scoreboard. From this point on, every time the scoreboard is switched on the connection to this
Console will be established automatically, without need of repeating the procedure. The linking procedure must be
repeated only when you wish to connect the Radio Receiver to another Command Console.
Please note that all switched-on Radio Receivers will permanently link to the Console, providing that they are not
already communicating with other Consoles.
3.3. Testing the Radio Receiver
Once the Radio Receiver has been installed and linked to the Command Console:
• Make sure that the scoreboards display all the information present on the Console's screen; otherwise, see
chapter 7.
4. C
ONFIGURATION
The configuration dip-switches are present on the internal electronic card which can be reached opening the
Radio Receiver case.
SW1
5. S LED
IGNALING
The Radio Receiver contains a red LED. It provides the following indications:
• off: no power supply;
• on: there is power supply but no data are received from the console;
• fast blinking (5 times per second): data are received by wireless communication (with FS1 or FS2 protocols).
F E
AVERO LECTRONICS SRL
D -
IP SWITCHES
The radio communication is not performed with FS1 protocol.
OFF
Note: Console-320 can be used only with FS1 protocol.
The radio communication is performed with FS2 protocol.
ON
Note: use the FS2 protocol with Console-700.
S
è . Set the "Connect new scoreboards" parameter to the
5 / 26
00302-M01-03-ML - FOS2 Radio Receiver Installation Manual
ENGLISH