Electrical Connection - S&P VA-900 BLACK Manual De Instrucciones

Avoid open flames, as they are harmful for the filters and can cause
fires.
Keep hot oil under control at all times to avoid it catching light.
Although the appliance has a power switch, a single pole switch with a
minimum gap of 3 mm between contacts and adequate for the total
current must be fitted between the appliance and the mains, in
compliance with national regulations.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children must be supervised to ensure that they do not play
with the product.
Children must be supervised to ensure that they do not play with the
product.
Before carrying out any maintenance or cleaning operations, always
disconnect the hood from the mains.
When replacing bulbs always use bulbs of the same type and power,
never more powerful.
If the cleaning operations are not done respecting the instructions
indicated in « OPERATION AND MAINTENANCE », there is risk of fire.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES
TO PEOPLE AND/OR PROPERTY DUE TO NON-COMPLIANCE WITH
THESE WARNINGS.
2. INSTALLATION
The assembly and electrical connections should be carried out by a qualified technician.

2.1.- Electrical connection

The unit is to the double insulated
Make sure the mains voltage and frequency coincide with those on the characteristics plate on
the hood and the remote extraction unit.
The electrical connection must be carried out as follows:
Although this is a device with a switch, When installing the hood, it is advisable to fit it in such
a manner that the mains plug is accessible by the user. (Fig.2)
10
Brown = L (Line)
Blue = N (Neutral)
, therefore does not require an earth connection.