Replacement Parts; Service And Repairs - Stanley 7000LM Manual De Instrucciones

MAINTENANCE
Use only mild soap and damp cloth to clean the product. Never let any liquid get inside the
product; never immerse any part of the product into a liquid.

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.stanleyledlighting.com. You can also order parts from our Customer Care Center at
1-(877) 714-8669, Barbados at 18443395176, Columbia at 018005185201, Dominican
Republic at 18002039606, Trinidad and Tobago at 18002031746.

SERVICE AND REPAIRS

For assistance with your product, visit our website at www.stanleyledlighting.com or call, email
or write our Customer Care Center at 1-(877) 714-8669, Barbados at 18443395176, Columbia
at 018005185201, Dominican Republic at 18002039606, Trinidad and Tobago at 18002031746.
LutecUSA 149-B Houston Road, Troutman, NC 28166
Email: Service@Lutec.net
Be sure to include the product model number, name, address, phone and email along with a
short explanation best describing the assistance needed.
ACCESSORIES
WARNING:
should be used with this product.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
compliance could void the user's authority to operate the equipment. This Class B digital
apparatus complies with Canadian ICES-003.
To reduce the risk of injury, only STANLEY recommended accessories
8