DeWalt DW151 Manual De Instrucciones página 8

606564/DW151 10/1/02 10:20 AM
5. Low line voltage.
How To Drill
For accuracy drill a small lead hole before using the final size drill.
Large diameter drills will "walk" off center until drill reaches full
diameter at which point the outside diameter acts as a pilot in the
hole being drilled. This is not peculiar to magnetic drill presses, but
is general machine shop knowledge on any large hole drilling.
Brushes
Carbon brushes should be regularly inspected for wear. When the
cap is unscrewed, the spring and brush assembly may be withdrawn
from the tool.
Keep brushes clean and sliding freely in their guides. Carbon
brushes have varying symbols stamped into them, and if the brush
is worn down to the line closest to the spring, they must be replaced.
New brush assemblies are available at service centers.
Adjustments
This unit is designed with a lubricated gib and is adjusted at the factory.
The gib may by lubricated periodically with grease to ensure smooth
operation. The gib should be tight enough to retain the motor in the
upward (retracted) position. Should this need adjustment, tighten 5
self-locking set screws on the side of the drill press body.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your distributor or your local service center.
CAUTION: The use of any non-recommended accessory may be
hazardous.
If you need assistance in locating any accessory, call us at:
1-800-4-D WALT or contact D
E
Joppa Road, Baltimore, MD 21286
1. DW1561 Chuck Adapter for DW151.
2. Mandrels and hole saws up to 2"(51mm) diameter.
Page 5
WALT Industrial Tool Co., 701 East
E
3. Rotary cutters and pilots 7/16"(11mm) thru 2"(51mm) diameter.
4. Twist drill bits 1/4" (6mm) to 13/16" (21mm)
5. Taps 1/4" (6mm) to 13/16" (21mm)(DW159 only)
6. Reamers, Light Gauge 1/4" (6mm) to 5/8"(16mm)
Reamers, Heavy Gauge1/4" (6mm) to 1/2"(13mm)
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
E
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete
unit, transportation prepaid. Proof of purchase may be required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
5
WALT tools are covered by our: