Extension Cords; Circuit Breaker Protection - Remington GARDEN WIZARD 109312-01 Manual Del Propietário

OPERATING TILLER
WARNING: Read and under-
stand this owners manual before
operating this tiller. Make certain
you read and understand all
Safety Warnings on pages 2 and
3. Improper use of this tiller can
result in severe injury or death
from fire, electrical shock, or body
contact with moving parts.

EXTENSION CORDS

Always use proper extension cords with this
tiller. Use only extension cords marked for
outdoor use. The cord must be marked with
suffix W or W-A following the cord type
designations. Example: SJTW-A or SJTW.
Use proper sized cord with this tiller. Cord
must be heavy enough to carry current
needed. An undersized cord will cause volt-
age drop at tiller. Tiller will lose power and
overheat. Follow cord size requirements
listed below.
Cord Length AWG Cord Size
25 feet 16 AWG
50 feet 16 AWG
100 feet 14 AWG
150 feet 12 AWG
Keep cord away from rotating tines. Inspect
cord often. Replace damaged cords.
109363
RETAINING EXTENSION
CORD
The switch housing has an extension cord
hitch made from a series of alternating hooks
(see Figure 9). This feature can be used to
secure the receptacle end of the extension
cord to the tiller handle to prevent accidental
disconnection from the power cord. A belt
clip is also included to help manage the cord
by keeping it at the users side and away from
the tiller tines.
Securing Extension Cord to
Tiller
1. Start at approximately 6 inches from
receptacle end of extension cord and
weave the cord between the hooks on
the switch housing as shown in Figure
9, so that the receptacle is hanging be-
low the switch housing.
2. Begin weaving the extension cord on
top of the bottom hook and alternate
under and over hooks so that the cord
is ultimately on top of the last hook.
3. Plug the tiller power cord into the ex-
tension cord.
Figure 9 - Securing Extension Cord to
Tiller
7
OWNER'S MANUAL
CIRCUIT BREAKER
PROTECTION
This tiller is equipped with a circuit breaker
located in the top of the switch housing (see
Figure 10). The circuit breaker provides
over-current protection to the tiller motor
should the tines become jammed or locked
by a stone, root, or other obstruction.
If the circuit breaker should trip during use,
the white circuit breaker button will pop up
out of the case and the electric motor and the
tines will stop rotating.
Resetting the Breaker
1. Fully release the trigger lever.
2. Unplug the tiller power cord from the
extension cord.
3. Dislodge or remove any obstacles from
the tines which caused the tines to jam.
WARNING: Always unplug the
tiller before placing hands near
the tines. Always wear gloves to
protect your hands from the sharp
edges of the tines.
4. Press the white circuit breaker button
back into the housing to reset (see Fig-
ure 10). The button should stay de-
pressed when released. Plug the tiller
power cord back into the extension cord.
5. Firmly grasp the tiller grip area on the
handlebar, and resume tilling.
Circuit
Breaker
Set
Figure 10 - Circuit Breaker Button
For more information, visit www.desatech.com
Circuit
Breaker
Tripped
Continued