Channel Number Setting; Operation - Toa WM-5325 Manual De Instrucciones

8. CHANNEL NUMBER SETTING

Step 1. Turn off the power switch, and then remove the battery
cover.
Step 2. Using the supplied screwdriver, set the Channel setting
switch pointers to the desired channel number.
Step 3. Replace the battery cover.
Note
Make sure that the wireless transmitter is identical to the wireless
tuner in the channel number. Should the transmitter's setting
differ from that of the tuner, the tuner does not receive the
microphone signal.

9. OPERATION

Step 1. Plug the microphone's plug into the input connector as illustrated.
Step 2. Confirm that the wireless transmitter and the wireless tuner are identical in the channel number.
If not identical, turn the power ON/OFF switch to the OFF position, then set the channel number to the
same one as the tuner.
Step 3. Turn the Power ON/OFF switch to the ON position. Then, confirm the green LED of the Power/Battery
lamps will light.
When using with the WH-4000P Waist Pouch, put the unit into the waist pouch as shown in the figure
below.
Step 4. Turn the Power ON/OFF switch to the OFF position after use.
WM-5325
Secure the connection with the plug lock.
8
Belt
1
Plug lock
Channel setting switch
WH-4000P
Hook and loop fastener
3
Plug lock