Fan Operation - Hitachi RAS-18G4 Manual De Instrucciones

FAN OPERATION

You can use the device simply as an air circulator. Use this function to dry the interior of the indoor unit
at the end of summer.
RESET
FAN SPEED (AUTO)
For the cooling operation
CIRCULATION OPERATION
RESET
Press the FUNCTION selector so that the display indicates
1
(FAN).
2
Press the
START
Press the
with a beep. Press the button again to stop operation.
STOP
* Note • In the fan operation mode, only display of FAN SPEED
setting will change by pressing FAN SPEED button; the
actual fan speed cannot be changed directly from HI to
LOW mode.
..... When the AUTO fan speed mode is set in the cooling operation:
G When the difference of room temperature and setting temperature is
large, fan starts to run at HI speed.
G After room temperature reaches the preset temperature, the cooling
operation, which changes the fan speed and room temperature to obtain
optimum conditions for natural healthful cooling will be performed.
Press the FUNCTION selector so that the display indicates
1
(CIRCULATE).
2 Press the FAN SPEED button and select the desired FAN
SPEED (the display indicates your choice).
Press the temperature control button to set to the desired
3
temperature.
START
Press the
starts with a beep. Press the button again to stop operation.
STOP
I As the settings are stored in memory in the remote controller,
you only have to press the
(FAN SPEED) button.*
(START/STOP) button. Fan operation starts
(START/STOP) button. Circulating operation
(START/STOP) button next time.
– 10 –