Before Starting The Equipment; Important; Operation; Replacing The Power Cable - EINHELL TE-RS 40 E Manual De Instrucciones Original

•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the additional handle (Fig. 2)
Place the additional handle (7) on the equipment
as shown in Fig. 2, insert the lock bolt through the
hole and fasten it on the other side with the clam-
ping screw (8).
5.2 Fitting the dust collection box (Fig. 3)
The dust collection box (6) must be pushed onto
the connector for the dust collection box (5). Push
the dust collection box (6) onto the equipment
until you hear it click clearly. To remove the dust
collection box (6), press the locking knob (9) and
pull the dust collection box to the rear and off .
The dust is extracted directly through the abrasive
paper and the grinding/sanding disk into the dust
bag.

Important!

For health safety reasons it is imperative that
you use the dust collection box.
Anl_SA_TE_RS_40_E_SPK8.indb 26 Anl_SA_TE_RS_40_E_SPK8.indb 26
GB
5.3 Fastening the abrasive paper (Fig. 6)
Easy replacement using Velcro fastening. Ensure
that the extractor holes on the abrasive paper and
grinding/sanding disc line up.

6. Operation

6.1 Switching the equipment ON/OFF (Fig. 4)
To switch on:
Push the ON/OFF switch (4) forwards.
To switch off :
Push back the ON/OFF switch (4) into its starting
position.
6.2 Speed control (Fig. 5/Item 3)
To pre-select the speed turn the knurled screw (3)
on the switch.
Plus direction:
Minus direction:
6.3 Working with the eccentric grinder/sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece completely
circular movements or moving it to and fro
and up and down.
•
Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the machi-
ne may be harmful.
•
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
•
Everybody who uses the machine or enters
the workplace must wear a dust mask.
•
Do not eat, drink or smoke at the workplace.
•
Do not use the machine on paints which con-
tain lead.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
authorized after-sales service or similarly trained
personnel to avoid danger.
- 26 -
Higher speed
Lower spee
15.03.16 10:54 15.03.16 10:54