Configuration (Standalone); Sound-Active Mode; Automatic Mode; Speed Adjustment - Chauvet DJ Swarm Wash FX Manual De Usuario

Configuration
(Standalone)
Sound-Active

Mode

Automatic Mode

Speed
Adjustment

Master/Slave

Mode
Page 26 of 124
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1. Press <MENU> repeatedly until SND blinks on the display.
2. SN1—SN15 blinks on the display and the Sound light comes on.
3. Use <UP> or <DOWN> to select the desired Sound-Active program.
4. Press <ENTER> to put the fixture into the selected Sound-Active mode.
5. Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
The laser will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
To enable the Automatic mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- blinks on the display.
2. P 1–P15 blinks on the display and the Auto light comes on.
3. Use <UP> or <DOWN> to select the desired Automatic mode.
4. Press <ENTER>.
To change the speed of Auto or Sound-Active mode, follow the instructions below:
1. Press <MENU> repeatedly until S-- shows on the display.
2. Press <ENTER> and S.01–S.99 will show on the display.
3. Use <UP> or <DOWN> to adjust the program speed.
4. Press <ENTER>.
The Master/Slave mode allows a single Swarm Wash FX product (the master) to control the
actions of one or more Swarm Wash FX products (the slaves) without the need of a DMX
controller. The master will be set to operate in either Automatic or Sound-Active mode, while the
slaves will be set to operate in Slave mode. Once set and connected, the slave units will operate
in unison with the master.
Configure the products as indicated below.
For every slave:
1. Set the product's DMX address to d001.
· Configure all the slave units before connecting the master to the DMX daisy chain.
· The display on the slaves will continue to blink until the slaves are receiving a DMX
signal from the master.
For the master:
1. Connect the DMX output of the master to the DMX input of the first slave unit.
2. Set the master unit to operate in either Automatic or Sound-Active mode
· Make sure the master is the first unit in the DMX chain.
· Never connect a DMX controller to a DMX chain configured for Master/Slave operation
because the controller may interfere with the signals from the master.
· Do not connect more than 31 slaves to the master.
Swarm Wash FX User Manual (Version 1.1)