Channel Function
4
Color select
5
Strobe
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
Automatic Mode
To run the Scorpion Storm RGBY in automatic mode, follow the instructions below.
1. Press <MENU> repeatedly until AuF or AuS shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select from ALL, GbY, rbY, rGY, rGb, bY, GY, Gb, rY, rb, rG, Y, b, G, r,
or rdM.
4. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity on the Scorpion Storm RGBY, follow the instructions below.
1. Press <MENU> repeatedly until Sou shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select from S 0–9.
4. Press <ENTER>.
•
The product will only respond to low frequencies of music (bass and drums).
•
The laser will black out when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
Page 12 of 52
Value
Percent/Setting
163 168 Blue and Yellow strobe
169 174 Red, Green, and Blue strobe
175 180 Red, Green, and Yellow strobe
181 186 Red, Blue, and Yellow strobe
187 192 Green, Blue, and Yellow strobe
193 198 Red, Green, Blue, and Yellow strobe
199 204 Red and Green alternating strobe
205 210 Red and Blue alternating strobe
211 215 Red and Yellow alternating strobe
216 220 Green and Blue alternating strobe
221 225 Green and Yellow alternating strobe
226 230 Blue and Yellow alternating strobe
231 235 Red, Green, and Blue alternating strobe
236 240 Red, Green, and Yellow alternating strobe
241 245 Red, Blue, and Yellow alternating strobe
246 250 Green, Blue, and Yellow alternating strobe
251 255 Red, Green, Blue, and Yellow alternating strobe
000 004 No function
005 254 Strobe, slow to fast
255
Sound strobe
Scorpion Storm RGBY User Manual Rev. 1
Operation