Ferplast chef pro Manual De Uso página 5

panel (fig. A), in order to ensure a
perfect opening of the front door.
• Do not place the feeder in areas
subject to splashes of water or
high levels of relative humidity.
• Do not pack too much food into
the feeder (especially in the case
of fine granular food).
• This feeder is not designed for
underwater use.
• The CHEF PRO feeder can be
integrated into CAYMAN or STAR
aquariums. (in the CAYMAN
aquarium, once the feeder is in
position, we recommend leav-
ing the compartment door open
for greater efficiency and better
ventilation).
PROGRAMMING (FIG. B)
P1 / P2 / P3
Programming daily feeding sessions (up to 3 feeding ses-
sions per day).
I.e.: it's 8 a.m. and you press the P1 button, the feeder will
supply one food session daily at 8 a.m. The same with the
P2 and P3 buttons. If both LEDS are on at the same time, the
feeder has not yet been programmed.
+2 h
Regulation of the period of time between the programming
time and the time of the first, second or third feeding
session to be set:after pressing this button several times
(on the basis of the desired interval), press P1, P2 or P3
within 3 seconds (the yellow LED will flash quickly during
this period). Once programming has been completed, the
yellow LED will flash for as many times as the +2h button
was pressed, allowing you to ensure that you programmed
it correctly.
I.e.: it's 8 a.m. and you want to set 2 daily feeding sessions,
one at midday and one at 6 p.m.:
- press the +2h button twice;
- Press the P1 button within 3 seconds (the yellow LED
will flash twice, indicating a 4 hour time interval from
the current time);
- Press the +2h button 5 times;
- Press the P2 button within 3 seconds (the yellow LED will
flash 5 times, indicating a 10 hour time interval from the
current time).
P1 + P3
Putting the feeder in STAND-BY (the food will only be
supplied by pressing the MANUAL button); to reactivate
the previous programme, press these two buttons again at
the same time. During the stand-by phase, the yellow LED
will intermittently flash slowly. This function allows you to
use the feeder as a normal dispenser as and when required;
when you are going to be away, just press P1 and P3 to
restore automatic operation.
MANUAL
Manual feeding, independent from programmed settings
and stand-by.
P1 + P2
RESET of the current programmed settings.
BATTERY
When the red LED starts to intermittently flash slowly, the
batteries are running low and are only guaranteed to last for
another twenty days.
Warning! If the RED LED intermittently flashes quickly,
the feeder is malfunctioning!
INSERTING THE FOOD
• Make sure that the feeder is in the rest position (food
outlet hole closed by the relative hatch integrated in the
EN
IT
FR
D
NL
ES
PT
SK
CS
HU
SV
DA
RU
PL
5