Cleaning And Maintenance; Technical Specifications - Perel Tools EHH1200 Manual Del Usuario

4. Description
1. Power switch 0 – 1
2. Upper heating lamp switch
3. Lower heating lamp switch
4. Oscillation switch
5. Upper lid
6. Halogen heating lamp
7. Reflector
8. Honey comb grille
9. Grille
10. Base
11. Butterfly nuts
12. Safety switch
13. Power cord guide
5. Installation
• Remove the fixture screws (11) at the bottom of the device.
• Remove the cable guide (13) from the base. Push the lips slightly and take the guide out.
• Fix the base (10) to the body of the appliance after feeding the mains cable through the central hole in the base.
Make sure the holes coincide with the holes of the previously removed screws.
• Pass the cable through the lips holding the guide (13) and through the hole in the back of the base.
• Place the cable guide in its original position and fix the body of the heater onto the base.
6. Use
• Place the device on a flat surface.
• Plug the device into the mains.
• Press the power switch (1) to start the central part of the appliance only (minimum power).
• Press the upper heating lamp switch (2). The heater's centre and top parts will be switched on (half power).
• Press the lower heating lamp switch (3) to obtain maximum power.
• The body of the heater can turn in a 60° angle. Press the switch (4). Press this button again to stop the rotating
motion and to leave the body of the heater orientated towards the desired place.
• Orientate the body of the heater by hand as well.

7. Cleaning and Maintenance

1. Disconnect the device from the mains prior to maintenance activities.
2. Wipe the device regularly with a clean, lint-free cloth. Do not use water, alcohol or solvents.
3. Clean the inside of the heater with compressed air.
4. Do not open the device for cleaning.

8. Technical Specifications

Power Supply
Heat Settings
Dimensions
Total Weight
The information in this manual is subject to change without prior notice.
EHH1200_v2
230Vac/50Hz
400W / 800W / 1200W
350 x 170 x 590mm
3.6kg
4 PEREL