Scope Of Delivery And Unpacking Of The Device; Unpacking Of The Device; Standard Equipment; Device Installation - ENBIO S Manual De Usuario

ranty service, any damage to the Customer's property other than this de-
vice, or errors caused by improper installation and/or improper operation
of the device.
Detailed recommendations, coutnerindications and warnings are
described in the relevant sections.
2. SCOPE OF DELIVERY AND UNPACKING OF THE
DEVICE.

2.1 Unpacking of the device

If the steriliser was transported or stored at a temperature or hu-
midity different than that at the location of installation, wait for 60
min. When moved from a cold room to a warm one, the device may
contain moisture that, by negatively affecting the device's electrical
components, may cause damage to it after startup.
Remove the device from its packaging carefully.
Attention! Check the packaging and its contents for external
damage. If damage is found, contact the seller or the transport
enterprise to prepare a damage report.
It is recommended to leave the carton for possible autoclave
port.

2.2 Standard equipment

Verify the contents of the packaging in which the device has been deliv-
ered prior to installing it. The delivery packaging should contain:
1. ENBIO sterilisers
2. Water and condensate connection cables, rubber plugs for water/con-
densate containers
35
3. USB drive
4. Operating Manual
5. HEPA filter
6. TÜV Certificate
7. Validation report
8. Certificate
9. Invoice
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE
COUNCIL of 4 July 2012 on waste electrical and electronic equipment
(WEEE), collection point registered with the General Inspectorate of
Environmental Protection; this unit handles selective waste collection.

3. DEVICE INSTALLATION

We recommend reading this user manual carefully before using the
ENBIO device. Follow all applicable safety guidelines and OHS regu-
lations when operating the device.
Mounting the HEPA filter. For reasons of transport safety, the HEPA
filter has not been installed in the device. Remove it from the bag
placed in the carton and tighten it yourself in a specially designated
place on the back of the device. The filter should be screwed in
trans- manually until resistance is felt.
a. The ENBIO S / ENBIO PRO should be positioned on a flat, even surface. Do
not use the device if it is inclined.
b. The device should be connected to a power supply that is earthed,
equipped with fuses and has the same voltage rating as that indicated
on the device.
c. Demineralised or distilled water can be used in the device. Under no
circumstances should tap water be used.