Orbegozo PHF 40 Manual De Instrucciones página 11

PHF 40
USER INSTRUCTIONS
CAUTION:
• Read this manual attentively before assembling.
• IMPORTANT: ensure that the various parts of the device are closely
attached to each other once the assembly is complete and before turning
the device on. Before the product is not fully assembled it shall not be
connected to the power supply.
• Ensure that your voltage corresponds to the supply voltage required by
this device (AC 230-240V ~ 50Hz). See the rating plate affixed to the
device. Also, make sure the device is grounded. The circuit power must
be equal or higher to 10 amperes.
• To reduce the risk of fire or electrical shocks, the device plug must be
perfectly adapted to the outlet. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or a similarly qualified
person in order to avoid a hazard.
• The device must always remain on a flat and stable surface whether
indoors or outdoors.
• Do not touch or move the device while it is on to avoid burns.
• Outdoors, do not place the device near a pool.
• Carefully unwind the electrical cord and ensure that it does not touch the
device. Never place the device under an electrical outlet.
• Do not use this device with a programmer or any device that
automatically turns the heat on; this could cause a fire if the device is
poorly positioned or covered.
• The fireguard is intended to prevent direct access to the heating
elements and must be in place when the heater is on. This fireguard may
not suffice to protect children or infirm persons. Do not let them use
the appliances without supervision.
ENGLISH
11