Taurus CLIMA TURBO 2000 Manual De Instrucciones página 14

parts/accessories.
- CAUTION: There is a risk of fire if the
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
Installation
- Be sure to remove all packaging material from
inside the appliance.
- Install the appliance away from flammable ma-
terial such as textiles, cardboard or paper, etc.
- Install the appliance a minimum distance of
50cm away from combustible materials, such as
curtains, furniture ...
- Ensure that neither the air access nor exit beco-
me either totally or partially covered by drapery,
clothing, etc., as this increases the risk of fire.
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- To achieve the highest efficiency from the
appliance it should be situated in a place where
the atmospheric temperature is between 12 and
32ºC.
- The appliance should be used with its base feet
fitted.
Fitting the base feet:
- The appliance has anti-slip base feet (E) that
support the product.
- To assemble the base feet, place the appliance
face down.
- Position the base feet on the body of the
appliance.
- Fix the feet using the screws provided (fig 1).
- Stand the appliance up again so as to check
that the base feet work properly.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
Use:
- Unroll the cable completely before plugging it in.
- Attach the appliance to its base making sure
that it is correctly fitted into place.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using the power
selector knob.
- The pilot light (G) comes on.
- Select the desired power.
- Turn the thermostat control to the desired tem-
perature position.
- During the appliance's use the pilot light (G)
will come on and off automatically, indicating
the heating elements are working, and therefore
maintaining the desired temperature.
Once you have finished using the appliance:
- Select the minimum position (MIN) using the
thermostat control.
- Turn the appliance off, using the power selector
knob.
- Unplug the appliance from the mains.
- Clean the appliance.
Carry handle/s:
- This appliance has handles on the side of the
body, which facilitates comfortable transport (Fig.
2).
Safety thermal protector:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, check to ensure that there
are no obstacles that impede correct air entry
or expulsion, then disconnect it from the mains
supply, and wait for approximately 15 minutes be-
fore reconnecting. If the machine does not start
again seek authorised technical assistance.
Cleaning
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Remark: When the appliance is used as a
heater after long periods in storage or after
having been used solely as a fan a small amount
of smoke may be produced. This is not important
and is due to the heater burning dust deposits
which have accumulated on the heating element.