Setting The Range; Setting Hygiene Flushing; Maintenance And Servicing; Replacing An Aerator - Frank PR3O0003 Instrucciones De Montaje

14. Setting the Range

The signal range can be adjusted with a free program available from Franke.

15. Setting Hygiene Flushing

Hygiene flushing can be adjusted with a free program available from Franke.

16. Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and
regulations applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Aerators (see
• Filters (see
• Non-return valves (see
16.1 Switch the fitting into the cleaning mode via the AQUA 3000 open system software.
or wait
Switch the fitting into the cleaning mode via an external switch on the ECC function
controller.
or wait
Disconnect the cable connection between the fitting and the electric T-junction.
16.2 Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.

17. Replacing an Aerator

17.1 Use the special wrench (b; see
aerator (a).

18. Replacing the Grit Filters

Filter for corner valve
18.1 Close the corner valves (c).
18.2 Trigger the valve.
18.3 Unscrew the connector hoses (a) from the corner valves.
18.4 Replace the grit filters (b).
18.5 Reassemble in the reverse order.
Chapter 17.)
Chapter 18.)
Chapter
Chapter
info@hygiene-shop.eu - www.hygiene-shop.eu
19.)
22.) to unscrew and remove the anti-theft
9