Operation - haacon S 2000 Plus Instrucciones De Uso

Ocultar thumbs Ver también para S 2000 Plus:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4. Operation

To extend the spindle support device
l Park the trailer vehicle on firm, even ground (see the
operating manual for the trailer vehicle).
l Check the support device for signs of damage, repair it
before use if necessary.
l Before activating the spindle support device swing the crank
handle out of its holder and engage it on the crankshaft.
Switch to high gear:
Only extend and retract the support device in high
gear when it is not loaded to lower it down to the ground.
l Pull out the crankshaft with the crank handle until the catch
engages.
- A slight turning movement will make it easier to engage.
l Extend the spindle support device by turning the crank
handle anti-clockwise.
Switch from high gear to low gear before the foot
reaches the ground.
Switch to low gear:
to raise and lower the loaded or unloaded trailer vehicle
l Push the crankshaft in with the crank handle until the catch
engages.
- A slight turning movement will make it easier to engage.
l In low gear raise the semi-trailer to the required height and
leave the crank handle in low gear.
Watch for the lifting limit (the force required to turn the
crank handle rises).
l At the end of the turning movement slowly relieve the strain
on the crank handle.There is a danger that the crank handle
will jump backwards.
After every operation switch the gear to low gear.
Always place the crank handle in the holder
provided for it.
to retract the spindle support device
l Follow the above instructions in reverse.
l After coupling the trailer, fully retract the spindle
support device.
Watch for the lifting limit (the force required to turn the
crank handle rises).
After every operation switch the gear to low gear. Always
place the crank handle in the holder provided for it.
To load the supported trailer vehicle
If the appropriate safety regulations are observed, the
supported trailer vehicle may be
l loaded using a crane and
l driven on with a forklift truck
Do not exceed the centre of gravity, otherwise the
trailer vehicle will tip over.
– 12 –

Publicidad

Tabla de contenido
loading

Tabla de contenido