For Your Information - Hazet-Werk 4811-1/2 Instrucciones De Uso

USA
Dear Customer,
You have made a good choice. This
HAZET tool in front of you is a high-
quality product that will make your
work easier.
1. General information
• Please take care that the user of this tool
carefully reads these operating instructions
and understands all information given in there
before the first use.
• These operating instructions contain important
advices that are necessary for a safe and trou-
ble-free operation of your HAZET Endo scope.
• For effective use of the endoscope as intended,
it is essential that all safety and other informa-
tion in these operating instructions is adhered
to.
• For this reason, always keep these operating
instructions together with your HAZET Endo-
scope.
• This tool has been designed exclusively for par-
ticular applications. HAZET emphasizes that
any modification of this tool and/or an applica-
tion that does not correspond to its intended
application is strictly forbidden.
• HAZET will not be liable for any injuries to
persons or damages to property that are due
to an improper application or misuse of this tool
respectively due to the disregard of the safety
instructions.
• Furthermore, the general safety regulations
and regulations for the prevention of accidents
being valid for the application area of this
device have to be observed, too.
2. Explanation of Symbols
ATTENTION: Please pay attention to these sym-
bols!
Read the Operating Instructions!
The operator is obliged to observe the
operating instructions and has to
instruct all users of the tool according
to the information given in this manual.
NOTICE!
This symbol marks indications which
help you to use the device.

For Your Information

CAUTION!
ATTENTION!
3. Liability and Warranty
• Any deviation from the intended
• Any claims against the manufacturer and/or its
• Any personal injury or material losses caused
4. Spare Parts
• Only use the manufacturer's original
• Unsuitable or defective spare parts may cause
• When using spare parts that are not
5. Disposal
• For disposal, clean device and disassemble
Do not look at light sources!
Blicken Sie nicht in Lichtquellen! Blicken Sie nicht in Lichtquellen! Blicken Sie nicht in Lichtquellen!
Minimum bending radius 30 mm!
Kleinster Biegeradius 30 mm! Kleinster Biegeradius 30 mm! Kleinster Biegeradius 30 mm!
This symbol marks important specifica-
tions, dangerous conditions, safety
risks and safety advices.
This symbol marks indications whose
disregard results in damage, malfunc-
tion and/or functional failure of the
device.
use and/or any misapplication
of the tool is not allowed and will be consid-
ered as improper use.
authorized agents because of damage caused
by improper use of the tool are ex cluded.
by improper use are the sole responsibility of
the operator and user.
spare parts.
damage, malfunction or the tool's total failure.
approved, all warranty and service claims as
well as all claims for compensation and liability
against the manufacturer or its agents, distribu-
tors and sales repre sentatives will be void.
according to regulations for environmental pro-
tection and for work safety. Components can
be recycled.
GB GB GB
7