Twin Star Home 28MM6307 Manual De Instrucciones página 6

3. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 2. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly. From
the inside, attach Mantel/Top (G) using Bolt (AA) and
Washer (BB) through the pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
4. Attach Side Back Panels (O) and Center Back Panel
(N) to the back of the completed assembly from step
3. Use a Phillips Head Screw Driver, tighten Wood
Screws (EE) through the pre-drilled holes in the Side
Back Panels (O).
Hardware Used
EE
Screw
5. Locate Right Front Door (L) and Left Front Door (K).
Slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change keyhole
slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (DD) to the Left Front Door (K) and
Right Front Door (L), use the bolts attached through
the pre-drilled holes in the doors. Then use a Phillips
Head Screwdriver to tighten the bolts.
Hardware Used
DD Knob
Fig. 3
CC
x 10
x 10
x 8
Fig. 4
x 28
Fig. 5
x 2 K
5
G
BB
AA
EE
J
J
I
I
L
CC
DD