LaserLiner AC-Check Manual De Instrucciones página 8

Additional information on use
Observe the technical safety regulations for working on electrical
systems, especially: 1. Safely isolating from power supply, 2. Securing
to prevent system being switched on again, 3. Checking zero
potential, two-pole, 4. Earthing and short-circuiting, 5. Securing and
covering adjacent live components.
Safety instructions
Using artificial, optical emission (OStrV)
LED outlet
• The device works with LEDs of risk group RG 0 (exempt, no risk)
in accordance with the latest versions of applicable standards
relating to photobiological safety (EN 62471:2008-09ff / IEC/TR
62471:2006-07ff).
• Radiation power: Peak wavelength equals 456 nm. Mean radiance
is below the limit values of risk group RG 0.
• When used for the intended purpose and under reasonably
foreseeable conditions, the accessible radiation of the LEDs
is safe for the human eye and skin.
• Temporary, irritating optical effects (e.g. dazzling, flash blindness,
afterimages, colour vision impairment) cannot be completely ruled
out, especially under low ambient light conditions.
• Do not intentionally look directly into the radiation source for
longer periods of time.
• No specific measures are required to ensure the limit values of risk
group RG 0 are maintained.
Safety instructions
Dealing with electromagnetic radiation
• The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive
2014/30/EU.
• Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards or
interference or be subject to hazards or interference.
08
EN