Inserting Batteries - LaserLiner AC-Check Manual De Instrucciones

Symbols
Warning about hazardous electrical voltage:
Unprotected live components inside the device
housing are capable of posing a risk of electric
shock.
Protection class II: The test device has reinforced
or double insulation.
Overvoltage category III: Equipment in fixed
installations and for applications where specific
requirements with regard to the reliability and
availability of equipment have to be met, e.g.
circuit-breakers in fixed installations and devices
used in industrial applications which are
permanently connected to the fixed installation.
1
5
1 Detector tip
2 ON / OFF
Adjustment
of sensitivity
1

Inserting batteries

Open the battery compartment and
insert batteries according to the
symbols. Be sure to pay attention
to polarity.
Before using the device, you should always test it on a
main circuit you know to be operational within the specified
!
voltage range. To avoid inaccurate measurements, check the
device batteries prior to use by switching on the built-in
battery lamp (see 5).
2
4
3 Pocket clip
4 Battery lamp
ON / OFF
AC-Check
3
6
5 Battery lamp
6 Battery compart-
ment on the rear
of the device
EN
09