Depth Adjustment - Makita DFS452 Manual De Instrucciones

Reversing switch action
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
1
► 1. Reversing switch lever
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever
to the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
When not operating the tool, always
set the reversing switch lever to the neutral position.

Depth adjustment

A
1
A
► 1. Locator
The depth can be adjusted by turning the locator. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the locator equals 2 mm
(1/16") change in depth.
B B
A
B
B
3 mm (1/8")
1
► 1. Locator
Adjust the locator so that the distance between the tip
of the locator and the screw head is approximately 3
mm (1/8") as shown in the figures. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjust-
ing until you obtain the proper depth setting.
Hook
CAUTION:
• Always remove the battery when hanging the
tool with the hook.
• Never hook the tool at high location or on poten-
tially unstable surface.
► 1. Hook
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
7 ENGLISH
1