DenMat GRIPPERTRAY SPD1414 Instrucciones De Uso página 2

English
DESCRIPTION: Disposable super rigid, plastic tray frame with thin mesh webbing used to capture
simultaneous crown and bridge, bite registrations and opposing impressions.
DIRECTIONS FOR USE:
1. Place unloaded Gripper Tray into proper position. When using the posterioror quadrant tray,
make sure the end of the tray is distal to the last maxillary tooth and the tray is centered
buccally/lingually.
2. Instruct the patient to "close" on the unloaded tray. Inspect the opposite side of the
patient's mouth to ensure that the patient is closed into the correct occlusion. To record the
most accurate bite registration, take the impression with the patient in an upright position.
3. Paint impression adhesive on tray walls only, not on the webbing. Overload both sides of
the tray.
NOTE: Gripper Tray must be used with a firm setting material. It may also be used with hard
setting Heavy Body/Light Body one-step techniques. Two-step techniques and putty
materials are not recommended.
4. Remove retraction cord if used, wash the area thoroughly. Syringe impression material
around the area to be recorded.
5. Load Gripper Tray with impression material.
6. Place loaded Gripper Tray into proper position and have the patient close properly.
7. When set, gently remove from mouth.
HOW SUPPLIED: 40 Gripper Trays per box.
SPD1414 Gripper Tray Anterior
SPD1415 Gripper Tray Posterior
SPD1416 Gripper Tray
STORAGE: No particular storage requirements necessary.
PRECAUTIONS:
General: Single use only.
CAUTION: Federal (USA) Law restricts sale of this device to, by or on the order of a dental professional.
Patent Pending
The Gripper Tray
Super Rigid Bite Trays
SPD1417 Gripper Tray Full Arch Large
SPD1418 Gripper Tray Full Arch
/ Arch SPD1541 Gripper Tray Sideless Posterior
3
4
®