Safety Instructions - Rockwell RK7241S Manual De Instrucciones

Jobsite table saw with laser
aCCessories
sTaNdaRd aCCEssORiEs
Wrenches
Rip fence
45°Miter gauge
Push stick
Riving knife
dust bag
Guard assembly
blade
OPTiONaL aCCEssORiEs:
finisher (RW9188)
sliding Extension table (RW9189)
dado insert (RW9556)
We recommend that you purchase your accessories
from the same store that sold you the tool. use good
quality accessories marked with a well-known brand
name. Choose the type according to the work you intend
to undertake. Refer to the accessory packaging for
further details. store personnel can assist you and offer
advice.

saFetY iNstruCtioNs

reaD all iNstruCtioNs beFore usiNG this
aPPliaNCe
iNstruCtioNs PertaiNiNG to a risK oF iNJurY
GeNeral
a. GrouNDiNG iNstruCtioNs
1. all grounded, cord-connected tools:
in the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric shock.
This tool is equipped with an electric cord having an
equipment-grounding conductor and a grounding
plug. The plug must be plugged into a matching
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
do not modify the plug provided – if it will not fit the
outlet, have the proper outlet installed by a qualified
electrician.
improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
The conductor with insulation having an outer
surface that is green with or without yellow stripes
is the equipment-grounding conductor. if repair
10
or replacement of the electric cord or plug is
necessary, do not connect the equipment-grounding
conductor to a live terminal.
2
Check with a qualified electrician or service
1
personnel if the grounding instructions are not
1
completely understood, or if in doubt as to whether
1
the tool is properly grounded.
1
use only 3-wire extension cords that have 3-prong
1
grounding plugs and 3-pole receptacles that accept
1
the tool's plug.
1
Repair or replace damaged or worn cord
immediately.
2. Grounded, cord-connected tools intended
for use on a supply circuit having a nominal
rating less than 150V:
This tool is intended for use on a circuit that has an
outlet that looks like the one illustrated in sketch
a in figure 1. The tool has a grounding plug that
looks like the plug illustrated in sketch a in figure
1. a temporary adapter, which looks like the adapter
illustrated in sketches b and C, may be used to
connect this plug to a 2-pole receptacle as shown
in sketch b if a properly grounded outlet is not
available. The temporary adapter should be used
only until a properly grounded outlet can be installed
by a qualified electrician. The green-colored rigid
ear, lug and the like, extending from the adapter
must be connected to a permanent ground such as a
properly grounded outlet box.
3. Grounded, cord-connected tools intended
for use on a supply circuit having a nominal
rating between 120V, inclusive:
This tool is intended for use on a circuit that has an
outlet that looks like the one illustrated in sketch
d in figure 1. The tool has a grounding plug that
looks like the plug illustrated in sketch d in figure 1.
Make sure the tool is connected to an outlet having
the same configuration as the plug. No adapter is
available or should be used with this tool. if the tool
must be reconnected for use on a different type of
electric circuit, the reconnection should be made by
qualified service personnel; and after reconnection,
the tool should comply with all local codes and
ordinances.
4. Permanently connected tools:
This tool should be connected to a grounded metal
permanent wiring system; or to a system having an
equipment-grounding conductor.
eNG