Mounting - Eneo EDC-AKS1 Instrucciones De Manejo

Cable assignment (network plug)
Pin Colour
 orange
 orange / white
3 green
4 blue / white
5 blue
6 green / white
7 brown
 brown / white
Wire colours according to EIA/TIA 56B

5. Mounting

CAUTION: Refer all servicing to qualified service personnel.
Seal this using the Teflon tape
around a thread of a socket.
. Drill 4 holes on the wall to fix the mounting base.
CAUTION: • For safety, the structure wall that this unit is installed on should be strong enough to support
a minimum of 25kg.
• For safety, connect a Ass'y Dome Housing under 9kg to the nut.
. Insert the plastic anchors inside each hole.
3. Attach the mounting base by using the screws (PTS M6) and the plastic anchors on the wall.
4. Fix the BNC cable with the cable clamp within the mounting.
5. Close the mounting and tighten the screws.
NOTE: You can prevent moisture from generating inside as sealing gaps between PGs and cables
completely.
Ethernet
Transmit Data +
Transmit Data –
Receive Data +
not used –
not used +
Receive Data –
not used +
not used –

Connected
yes
yes
yes
–
–
yes
–
–