Control Panel - Panasonic EY7460 Manual De Instrucciones

CAUTION:
Check the speed selector switch
●
before use.
Use at low speed when high torque
●
is needed during operation. (Using
at high speed when high torque
i s r e q u i r e d m a y c a u s e a m o t o r
breakdown.)
Do not operate the speed selector
●
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the rechargeable battery to
wear quickly or damage the internal
mechanism of the motor.
* S e e s p e c i f i ca t io n s f o r " MA X I M U M
RECOMMENDED CAPACITIES".
CAUTION:
To prevent excessive temperature
●
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
Do not close up vent holes on the
●
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
Do NOT strain the tool (motor). This
●
may cause damage to the unit.
Use the tool in such a way as to
●
prevent the air from the body vent
holes from blowing directly onto your
skin. Otherwise, you may get burned.
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in place,
the tool can be used as a manual
screwdriver (up to 40 N·m, 408 kgf-cm,
353 in-lbs).
There will be a little play in the chuck,
but this is not a malfunction.
EY7460_EY7960_Book.indb 9
2. This feature is handy for tightening
screws that require more torque than
the maximum torque of the driver
(position on the clutch), for confirming
the tightness of a screw or to loosen an
extremely tight screw.

Control Panel

(1)
(1) LED light
Before the use of LED
light, always pull the power
switch once.
Press
button.
The light illuminates with
very low current, and it does not adversely
affect the performance of the tool during
use or its battery capacity.
CAUTION:
The built-in LED light is designed
●
to illuminate the small work area
temporarily.
Do not use it as a substitute for a
●
regular flashlight, since it does not
have enough brightness.
LED light turns off when the tool has
●
not been used for 5 minutes.
Caution: DO NOT STARE INTO BEAM.
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
- 9 -
(3)
(2)
the LED light
2013-12-2 16:12:25