Makita UV3600 Manual De Instrucciones página 10

• Inspect the machine on regular
base.
• Before servicing,
adjustment,
change an
following steps:
– Shut off the power source
– Disconnect
from power supply
– Make sure that all moving
parts have
complete stop
– Allow the machine to cool.
• Inspect on the machine for
possible damage:
– Whether
works
intended function
– Whether all the moving
parts work smoothly and
adequately
– Whether all parts are not
damaged
installed
– Check the cutting tool for any
damage, worn or unbalance
– Check the grass catcher
regularly for any damage or
worn
– Check all the nuts, bolts and
screws are tight
– Replace or repair by our
authorized service center if
there are any damaged or
worn parts.
• Do not carry out maintenance
or repair work other than that
described in this instruction
manual. Any other work must be
carried out by Makita authorized
service center.
10
inspection,
storage, or
accessory,
the machine
come to
safety devices
properly for
and properly
• Only
replacement
accessories intended for your
to machine. Otherwise it may result
take in personal injury or damage on
the machine.
• Store the machine in a dry room.
Keep it out of reach of children.
Never
outdoors.
a
Vibration
• People with poor circulation who are exposed to
excessive vibration may experience injury to blood
vessels or the nervous system. Vibration may cause
the following symptoms to occur in the fingers, hands
or wrists: "Falling asleep" (numbness), tingling, pain,
stabbing sensation, alteration of skin color or of the
skin. If any of these symptoms occur, see a physician.
• To reduce the risk of "white finger disease", keep your
hands warm during operation and well maintain the
its
equipment and accessories.
WARNING:
• This
electromagnetic
operation. It is recommended that
persons with medical implants
should consult their doctors and
implant manufacturers before
using this machine. Otherwise
the electromagnetic field may
affect medical implants and it
may result in serious injury.
ASSEMBLY
CAUTION:
• Always be sure that the machine
is switched off and unplugged
before carrying out any work on
the tool.
Assembling the handle bar (Fig. 2, 3)
1) Fasten the lower handle bar (4) to the machine with
the knobs (11).
2) Place the upper handle bar (3) onto the lower handle
bar, and then fasten them with two spacers, nut, and
the lever (7).
3) Fasten the cord with the clips (8) onto the handle bar.
use original
parts
store the
machine produces
field
Makita
and
machine
an
during