Bosch GAS20-17A Instrucciones De Funcionamiento página 11

2610051564_GAS20-17A 5/8/18 1:18 PM Page 11
A. Unlock the canister latches 4 and
remove the control unit 1 (Fig. 2).
B. Remove the bag 27 from the internal
dust port 2 by pulling the flange
towards the rear of the canister (Fig.
3).
C. For fully enclosed bags: Pull the
tab on the flange up until the
opening has been closed off by the
paper cover. Remove the bag from
the canister and dispose of
properly.
For plastic bags only: Remove the
bag from the canister and twist the
top of the bag. Tie off the plastic bag
below the port and dispose of
properly.
D. Wipe dust extractor with a damp
cloth to clean the dust residue.
Note: Avoid overfilling the 3-layer paper
filter bag in order to reduce the
likelihood of the bag tearing.
EPA Lead Based Paint Renovation,
Repair and Painting Program (RRP),
this dust
recommended for vacuuming carpets
and rugs. Dust extractor may not be
able to completely remove all
hazardous substance, which may
cause health and environmental
hazards.
Assembly and Preparation
When using this
dust extractor for
extractor is not
Not suitable to
vacuum hazardous
or toxic substances or dusts e.g.
asbestos. Neither the standard filter
nor the optional HEPA filter is able to
capture all hazardous particles, which
may cause health hazards.
NOTE: Read the OSHA regulation on
silica dust and the related OSHA
Silica Table 1 to understand the
requirements needed to reduce
exposure to silica dust at the jobsite.
Specific rules apply to the drilling,
demolition, cutting and grinding
materials that
According to OSHA Silica Table 1,
when dry cutting or dry surface
grinding concrete type materials using
hand held grinders, the dust extractor
(dust collector) being used must
provide 25 CFM or greater of air flow
per inch of wheel diameter.
All OSHA requirements can be found
at OSHA website:
www.osha.gov
Always check OSHA website for the
latest regulations.
When using the dust extractor in
concrete applications with related
tools and dust extraction attachments
(such as rotary / demolition hammers
or grinders), always follow the
instructions provided with the tools /
attachments to ensure proper dust
collection throughout the application.
11
contain silica.