DJO Global Cefar Femina Manual De Instrucciones página 54

54
CEFAR FEMINA is intended for use in the electromagnetic environment specified below. The customer or user of the CEFAR
FEMINA should assure that it is used in such an environment
Immunity Test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast transient/
burst IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power supply
input lines
IEC 61000-4-11
Power frequency
(50/60Hz) magnetic field
IEC 61000-4-8
NOTE: U T is the AC mains voltage prior to application of the test level.
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
IEC 60601
Test Level
±6kV contact
±8kV air
±2kV for power supply lines
±1kV for input/output lines
+ 1kV differential mode (line
to line)
+ 2kV common mode (line
to ground)
<5% U T (>95% dip in U T ) for
0,5 cycle
40% U T (60% dip in U T ) for
5 cycles
70% U T (30% dip in U T ) for
25 cycles
<5% U T (>95% dip in U T ) for
5 sec
3 A/m
Electromagnetic Environment -
Compliance Level
Floors should be wood, concrete
or ceramic tile. If floors are
±6kV contact
covered with synthetic material,
±8kV air
the relative humidity should be at
least 30%.
Not Applicable - Battery
Mains power quality should be
powered
that of a typical commercial or
Not Applicable - signal lines
hospital environment.
less then 3 meters
Mains power quality should be
Not Applicable - Battery
that of a typical commercial or
powered
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of the CEFAR FEMINA requires
continued operation during
Not Applicable - Battery
powered
power mains interruptions, it is
recommended that the CEFAR
FEMINA be powered from an
uninterruptible power supply or
a battery.
3 A/m
Power frequency magnetic
fields should be at levels
characteristic of a typical location
in a typical commercial or hospital
environment.
Guidance