Overheat Protection - HAEGER Elegance IX Instrucciones De Uso

Ocultar thumbs

Contenido

página de 33

/ 33
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

English

–

The radiator will reduce the effects of cold draughts to a minimum.

–

The appliance must not be positioned directly underneath a fixed power

point.

–

Do not use the appliance in rooms with a surface area of less than 4m².

Connection

The radiator must be connected to a perfectly functioning 220-240V AC socket

with correct poles.

Avoid contact between clothing, household linen, furniture, inflammable

material and the socket providing power to the radiator.

Operating your oil-filled heater

1. Room temperature can be adjusted using the thermostat. Simply turn the

thermostat knob clockwise, to increase the heat, and anti-clockwise to

decrease the temperature, until you reach the desired temperature.

2. Turn the power switch from "0" to either "●" (Minimum heating), or "●●"

(Medium heating) or "●●●" (Maximum heating).

3. The pilot lights up when activated.

4. Turning

the

temperature.

5. Turning the thermostat anti-clockwise will decrease the "set" temperature.

6. Do not cover the heater at any time during operation. There is a risk of fire

if the heater is covered.

7. Once you have finished using your heater, turn the power switches off, and

the thermostat control switch to the "0" position, and unplug from the

mains supply.

IMPORTANT: When in use, the radiator should always be kept vertical

(wheels at the bottom, controls at the top). Any other position could be

dangerous!

Tip-over protection

This heater is protected with a safety switch that turns off the appliance

automatically when the heater falls over or is at an excessive angle from the

horizontal. This helps prevent accidents, and the heater will resume operation

when it is put back upright.