HOFFLIGHTS SEYCHELLES Manual De Instalación página 23

REMOTE
CONTROL
SYNCHRONIZATION FROM 2 TO 5 FANS
Synchronization mode is used between remote control and receiver.
Turn on the general line the fans are connected to during 30 seconds until hearing the first "bip". Press the fan button
"ON/OFF" during five seconds until sounds a long "bip" which means pairing has been successfully.
If paring is not finalize during 30 seconds the process has to be repited by turning off the general line and on again.
One remote control can control a maximum of 5 fans.
KDINDLY REMINDERS
1. When the remote control cannot control the receiver, please check the battery POLE touching normally or not, correc-
tion of the positive and negative, full or empty of the power.
2. When the remote control cannot control the receiver, please check if there any existence of similar remote controlled
products nearby, then check whether they works, because remote controlled product with the same frequency will
disturb each other.
3. Low voltage of battery will affect the sensitivity of the remote control and the signal reception accordingly(the indica-
ted light will flash out its warning when the battery get low voltage), must replace if the battery is getting low voltage.
4. Please take out the battery from the remote control when leaving unused for long time
5. Supporting 140W lighting power at maximum.
6. PS: please connect the ground wire correctly, otherwise it may cause the light micro-light or flash
7. When installing the fan, the fan ceiling cover don't press the antenna (or other wire), it is easy to breakdown the wire
and short-circuited.
hofflights.com
USER MANUAL
IMH-100 v.01
23