Fuse Replacement - Ibiza Light LSM400LED Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Put the unit on a level surface and don't tilt or turn it upside down.
Don't spray the fog directly to people or into an open flame.
Power off or pull out the plug after use.
Please use only high quality fog liquid recommended by your dealer. Bad quality fog liquid may damage the
unit and may give rise to a toxic or fire risk.
Don't add tinder liquid such as oil, gas, perfume and etc. into the fog machine.
Check regularly if there is enough fog liquid left in the tank.
Close the cap of the fluid tank thoroughly after filling in fog liquid.
Remove all fog liquid from the unit before transport.
Don't swallow fog liquid. In case of accidental ingestion, contact immediately a doctor. Rinse thoroughly your
skin and eyes if they have been in contact with the fog liquid.
This appliance shall not be used by children below the age of 14 nor persons with reduced phys-
ical, sensory or mental capabilities or lack of experience and knowledge even if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children.
Please note that the unit is not for intensive professional use. FOR SAFETY REASONS, DO NOT LEAVE THE
UNIT SWITCHED ON OVER AN EXTENDED PERIOD OF TIME
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.

FUSE REPLACEMENT

Disconnect the power cord before replacing a fuse and always replace with the same type fuse
With a flat head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
INSTALLATION
1. Take away all packing material especially in the nozzle.
2. Set the unit on a level surface and loosen the cap of the fluid tank.
3. Add high quality water based fog liquid in the machine and screw the cap of the fluid tank. Bad quality fog
liquid will damage fog machine.
4. Plug the unit into an earthed mains outlet.
OPERATION:
1. Please turn on the unit via the switch on the rear panel. The machine will start
heating up. Set the I/O switch on the remote to "I" to start the fog machine. When
it has reached operating temperature, the neon switch on the remote control lights
up. Occasionally the neon switch will turn off and the pump will stop. This means
that the unit has cooled down and requires re-heating, the pump will not operate
whilst the heater is on and the switch will illuminate when the machine is again
ready to use.
2. Often check if there is enough fog liquid left in the tank. Operating the machine
without fog liquid might cause serious damages to the machine.
3. If the fog output is low, the unit makes an unusual noise or there is no fog output
at all, please power off and check fog liquid, fuse and power plug. If the problem
hasn't been solved after checking these parts, send it back to your dealer for
repair.
MAINTENANCE
Please clean the fog machine after about 40 hours of continuous use to avoid prob-
lems.
Mix 80% of distilled water with 20% of vinegar to remove the dirt in the nozzle.
Let the unit cool down.
Manual - LSM400LED
www.ibiza-light.com
EN
3

Publicidad

Tabla de contenido
loading

Tabla de contenido