Beper 90.660 Manual De Instrucciones página 8

Raclette Use instructions
Using the unit
Place the device on a heat-resistant surface.
1. Cut all the ingredients into small pieces or slices.
2. Lightly grease the baking plate.
3. Please ensure that the temperature regulator is turned to OFF. Connect the appliance to a duly.
The left-hand lamp goes on to signal that the device is connected to the mains power supply.
4. Turn on the machine by moving the regulator clockwise to the desired position.
The right-hand lamp goes on. If necessary, start on a low setting. The device has reached the cor-
rect temperature when the right-hand control lamp goes off. During operation the control lamp goes
on from time to time to show that the correct temperature is being maintained.
5. Choose the food to be grilled on the cooking plate. In the pans you can put for example mushro-
oms or small slices of bread with cheese to cook. To avoid damaging the non-stick coating, remove
the food with a wood spatula.
Warming function
Turn the temperature regulator to the lowest setting. The roasting plate now serves as a hot plate.
After Use
To switch the device off, first turn the temperature regulator to OFF and remove the plug from the
socket.
Cleaning
• Always pull the plug out of the mains socket and wait until the unit has cooled down before cleaning
the unit.
• Under no circumstances should the device be immersed in water for cleaning.
• Clean the pan in the usual manner in soapy water.
Non-stick coating
• Please remove any food residues while they are still warm with a damp cloth or paper towel.
• Wash off the coating with a soft sponge and soapy water, then rinse with clear water and dry tho-
roughly with a soft cloth.
• Do not use sharp objects to clean the appliance. Otherwise, the non-stick coating may be dama-
ged.
• Use a slightly damp cloth to clean the unit.
This device has been tested according to all relevant current CE guidelines, such as electromagne-
tic compatibility and low voltage directives, and has been constructed in accordance with the latest
safety regulations.
Subject to technical changes without prior notice!
8