Setting The Clock - Mx Onda MX-RDM5240 Manual De Instrucciones

AC EXTERNAL POWER SOURCE
1. Insert the plug of the power cable into connector 14 (AC 220V), located on the left
side of the device.
2. Plug the other end of the cable into a 230 V mains socket.
While the appliance is plugged into the 230 V mains and even when it is
switched off, the appliance is not disconnected from the mains, so it is
advisable to ensure that there is no danger in leaving it permanently
connected.
USE OF BATTERY
1. Disconnect the power cable from connector 14 (AC 220V).
2. Open the lid of the battery compartment 15 on the back of the appliance and insert
3 (preferably alkaline) batteries of 1.5 V type LR20, D, etc. respecting the polarity +
and - indicated on the back of the device.
3. Replace the battery cover.
IMPORTANT
If you do not intend to use the appliance for a long period of time, remove the
batteries and store them in a cool place.
Do not mix old and new batteries, or different types.
Never heat the batteries or throw them into the fire. Do not try to disassemble them
and do not short them.
The batteries that you use contain contaminant materials of the environment, for
that reason, once exhausted the life of the same DO NOT throw them away,
deposit them in the suitable place for their later recycling.

SETTING THE CLOCK

For the clock time adjustment, follow the following process:
1. The radio should be off.
2. Press and hold the 6 (TIME.SET) button.
3. Press the 4 (HOUR) button to set the time.
4. Press the 8 (MIN) button to adjust the minutes.
5. Stop pressing button 6 (TIME.SET) and the time will be
memorized.
SETTING IN TIME AND OPERATION OF THE ALARM
To start the alarm, you must first set the time you want it to be
activated, following the steps below:
1. The radio should be off.
2. Press and hold the 7 (ALARM) button, the display will show
the alarm activation time as well as the "
3. Press the 4 (HOUR) button to set the time.
4. Press the 8 (MIN) button to adjust the minutes.
5. Stop pressing button 7 (ALARM) and the alarm time will be
memorized.
WARNING!
" symbol.
4