Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Once the automatic activation time has been set, to connect the alarm press button
9 (AL.ON/OFF) and the screen will show the symbol "
connected.
Once the alarm has occurred, press the 9 (AL.ON/OFF) button to stop the alarm until the
next day. The duration of the alarm is 60 minutes and if it is not stopped manually, it will
automatically cease after this time.
To disarm the alarm press button 9 (AL.ON/OFF) and the symbol "
the screen, indicating that the alarm is disconnected.
To check the alarm activation time press button 7 (ALARM) and the display will show the
activation time as well as the "
VERY IMPORTANT
The alarm is produced by the radio, for the alarm to be effective take care to pre-tune
a radio station and adjust the volume level.
When the power supply to the device is absent, the clock will take the time preset
from the factory, so you must put the clock back on time.
USE OF THE RADIO
1.
To turn on the radio, slide the ON / OFF switch 12 (ON/OFF) to the ON position.
2.
Using the band selector 2 (AM/FM) choose the medium wave (AM) or frequency
modulated (FM) band.
3.
Turn tuning control 3 (TUNE) one way or the other and tune to a radio station.
4.
To adjust the volume level, turn the volume control 5 (VOL) one way or the other and
adjust the sound level according to your preference.
5.
To turn off the radio, slide the ON / OFF switch 12 (ON/OFF) to the OFF position.
Medium wave antenna (AM)
For the medium wave band (AM) this device incorporates an internal ferrite directive
antenna, if the received signal is not good turn the device until you get the best possible
reception.
Frequency modulated antenna (FM)
The telescopic antenna 11 is the frequency modulated (FM) antenna. To receive
stations in the frequency modulated (FM) band, you must fully extend the antenna and
direct it to where the radio stations are received with the minimum noise.
HEADPHONE OUTPUT
In connector 13 (EAR) you can attach headphones (not supplied) with a 3.5 mm jack.
When the headphones are plugged in, the sound of the speaker will be interrupted.
Note:
When listening to music through the headphones do not set the volume level too high,
as it could damage your ears.
" symbol.
5
" indicating that the alarm remains
" will disappear from
Publicidad
Tabla de contenido
