Skil 1560 Instrucciones De Funcionamiento página 8

BM 1619X02183 02-07
BLADE ALIGNMENT
To ensure an even cut, it is important that the
blade is adjusted so that it aligns with the
outside edge of the front and rear shoes. This
alignment can be done as follows: place a
straight edge or a piece of wood along the
outside surface of the front shoe and rear
FIG. 6
TRIGGER "ON/OFF" SWITCH
Hold the tool with both
!
WARNING
hands while starting the
tool, since torque from the motor can
cause the tool to twist.
To turn tool "ON": depress the "Lock-Off"
release button from either side and squeeze
the trigger switch.
To turn the tool "OFF": release the trigger
switch and it will return to "OFF" position
automatically.
To increase switch life, do not turn switch on
and off while tool and drum are held against
a workpiece.
PLANING ACTION
Check that the workpiece is held in place
securely on your work surface, and standing
comfortably, hold the planer firmly with both
hands. With the planer fully adjusted, place
the front shoe on the workpiece, (be certain
FIG. 9
2/8/07 11:55 AM
FIG. 7
Operating Instructions
Page 8
shoe, then slide the planer blade to just
contact the straight edge or wood (Fig. 7).
Make sure the blade sits correctly in the
holder groove of the cutter drum.
You may then tighten the clamping screws
which secure the blade and your planer is
ready for use (Fig. 8).
CLAMPING
SCREW
that the cutter drum is not in contact with the
work) and start the planer as described earlier
(Fig. 9). With pressure on the front shoe, and
the fence against the side of the work (to
control the width or angle,) feed the planer
steadily until the rear shoe fully engages the
workpiece. Now gradually transfer pressure to
the rear shoe, and continue planing to the end
of the cut (Fig. 10).
FIG. 10
Feed the planer at a uniform and reasonable
rate, which does not put excessive strain on
the motor or blades, (do not pull the planer
back over the surface already cut.) Use
progressive cuts until you are near the
desired depth, and then re-adjust to a light
cut for the final pass to obtain a good surface
finish.
The motor may stall if
!
CAUTION
improperly
overloaded. Reduce the pressure (feed
rate) or depth of cut to prevent possible
damage to the tool if the motor labors.
-8-
FIG. 8
BLADE
WRENCH
used or
C