Publicidad
Idiomas disponibles
Idiomas disponibles
APPLY PADS TO INSIDE OF BRACKETS.
• Peel pad from
backing material.
Clean surfaces
where brackets
will be installed.
All surfaces must be
free of grease or
debris.
*BED LINERS / BEDRAIL COVERS
The bracket and bolt anchor
surfaces must be flat against the
bedrail, completely free of gaps.
It is possible
that the
brackets may
not sit at four
corners of bed
due to
obstructions or
bedrail shape.
1033066A-2/12
• Be sure to match pad size
to surface size.
Determine where the
brackets will be
installed on the truck
bed rails.
Some bedliners or bedrail covers may
require alteration. It may be necessary
to cut away a section of the liner on the
underside of the bedrail.
ATTACH WASHER
AND NUT.
Tighten with a 3/4" wrench
just until brackets are held
in place.
Position anchor
under bed rail.*
WARNING
Installing the anchor with liner
material interfering can cause
the brackets and the load to fall
away from the vehicle, resulting
in property damage, personal
injury, or death.
Cover end
of bolt with
cap.
Position bracket
tube inside
truck bed.
If not flat, move along
the bedrail until flat.
Publicidad
