Lint Filter - Haier HLT364XXQ Manual Del Usuario

Lint Filter

• The lint filter must be used during washing
• It must be cleaned after each wash.
1. Take off the lint filter. Pull up the lint filter from the
inner tub.
2. Remove the lint filter.
3. Reinstall the lint filter.
Install the Inner Cover
1. Open the top lid of the washing machine.
2. Put the inner cover component on the outer tub cover, aiming the inner cover
shaft to the installation hole of the corresponding outer tub cover shaft groove.
3. Insert the inner cover shaft of one side into the corresponding outer tub cover
shaft groove, then push the other inner cover shaft into the corresponding
outer tub cover shaft groove.
4. Do not disassemble after installation.
English
8