Presentation - JMA TITAN Manual De Instrucciones

Máquina duplicadora
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
1

Presentation

and general points
1.1
General points
The E.U. safety regulations currently in force have been
taken into account in the design of the TITAN duplica-
ting machine.
The safety of personnel involved in the handling of this
type of machine is only achieved via a well designed
personal safety program, such as the implementation
of a maintenance program, and by following the
recommendations made in addition to adhering to the
safety regulations dealt with in this manual.
Although this machine is easy to install, it is advisable
not to attempt to install, adjust or operate it without
reading this manual first.
The machine leaves our factory ready for use, and only
requires the calibration operations for the tools which
are going to be used.
1.2
Transport and packaging
The TITAN machine comes in a robust cardboard box
padded with foam packaging. The dimensions of the
box are:
Width = 570 mm, length = 520 mm, height = 410mm
Weight of the machine plus packaging = 26.5 Kg
When unpacking the machine, inspect it carefully to
check that it has not been damaged during transport.
If any irregularities are discovered, inform the carrier
immediately and do nothing with the machine until a
representative from the carrier has inspected it.
1.3
Identification label
The TITAN duplicating machine is supplied with an iden-
tification label specifying the machine serial number or
registration number, name and address of the manufac-
turer, EC mark and year of
manufacture.See figure 1
8
2
Machine
characteristics
The TITAN machine is a semi-automatic, highly robust and
precise machine for cutting flat cylinder lock keys, vehicle
keys, cruciform keys and special keys.
2.1
Family of keys
The TITAN machine duplicates the following types of keys:
Flat keys.
Vehicle keys.
Cruciform keys.
Key nomenclature
2.2
Head
1
Neck
2
Top shoulder
3
Bottom shoulder
4
5
Teeth
Blade
6
Back
7
Tip
8
2.3
Main parts of the machine
Milling cutter
1
Brush
2
Motor
3
Wheel guard
4
Double sided clamp
5
Clamp handle
6
Carriage
7
Carriage handle
8
Carriage feed lever
9
Fold-away stop
10
Tracer
11
Tracer support
12
13
Start button
Brush operation switch
14
15
Tracer depth adjustment control
16
Tracer sideways adjustment control
Technical data
2.4
The main technical data is presented below:
Motor
: Single phase 220V, 50Hz, 0.18Kw,1350 rpm, 1.7 Amp.
or Single phase 110V, 60Hz,0.18Kw, 1700 rpm 3.14 Amp.
Milling
cutter: High speed steel Ø80 x 16 x5 mm.
Milling cutter turning
speed: 640 rpm.
Clamps: 2 sided steel.
Displacement: On self-lubricating bearings.
Effective
travel: X axis= 54 mm.
Dimensions: Width = 410 mm, Depth = 350 mm, Height = 240 mm.
Weight: 23 Kg.
See figure
2
See figure
3

Publicidad

Tabla de contenido
loading

Productos relacionados para JMA TITAN

Tabla de contenido