Optional Accessories - Makita M3601 Manual De Instrucciones

Ocultar thumbs Ver también para M3601:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Fig.11
► 1. Guide bar 2. Clamp screw 3. Straight guide
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight guide
cannot be used. In this case, firmly clamp a straight board
to the workpiece and use it as a guide against the trimmer
base. Feed the tool in the direction of the arrow.
A
Fig.12
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
3
2

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
Edge forming bits
Laminate trimming bits
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
Router bits
Straight bit
Fig.13
D
6
1/4"
8
6
1/4"
6
1/4"
7 ENGLISH
A
L1
20
50
8
60
8
50
6
50
Unit:mm
L2
15
25
18
18

Publicidad

Tabla de contenido
loading

Tabla de contenido