Technical Specifications - Perel Tools GMK1 Manual Del Usuario

3. Description
1. photocatalytic panel
2. capture opening
3. capture net
4. UV lamp
5. fan
6. on/off switch
4. Use
• Place the mosquito trap on a flat and stable surface. For best results, install the mosquito trap approximately
1.5m above the ground.
• Connect the PSU to the mosquito trap and plug into the mains.
• Switch the mosquito trap on or off with the on/off switch.
• Emptying the mosquito trap: Switch off the mosquito trap and disconnect from the mains. Unscrew the bottom of
the mosquito trap, empty the trap and clean the net. Reassemble the mosquito trap.
5. Replacing the UV-lamp
Refer to the pictures on page 2 of this manual.
• Switch off the lamp and disconnect from the mains.
• Remove the collecting container by twisting the container counter clockwise and pull. Now, twist the lamp
holder section and pull from the fan section.
• Gently unstick the electrical wire. Remove the 4 screws to uncover the PCB. Now, slide the PCB out of the
notches.
• Unsolder the connections of the lamp to the PCB. Remove the lamp and replace with a new one. Solder the
connections to the PCB. Slide the PCB back into the notches.
• Screw the PCB holder back into the lamp holder section with the 4 screws.
• Reassemble by repositioning the lamp holder section back onto the fan section and by twisting the container
back onto the assembly.

6. Technical Specifications

Power Supply
Power Consumption
Dimensions
Total Weight
Velleman nv cannot be held responsible in the event of damage or injury resulted from (incorrect) use of
this device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
GMK1_v2
12VDC through PSU (incl.)
3W
135 x 135 x 245mm
376g
4
PEREL