Optimus UMX-02/0 Manual De Instrucciones página 70

ENGLISH
2. Input Selection
An audio input and some audio outputs are
defi ned.
When the contact input and the priority of
the audio input are activated, the message
is sent to the audio outputs.
• Input: Enter the input number where
the message generating source has been
connected.
Press MENU/OK to save the data.
• Outputs: Enter the name of the output
or group of outputs to which the message
is to be sent. To add other outputs or
groups, press key
of the output or group that you wish
to add (maximum 100 outputs and/or
Eng
groups).
Press MENU/OK to save the data.
In section II. Confi guration / 7.2. a typical
example of an installation with microphone
with zone selection is shown.
3. Live Message
An audio input and some audio outputs are
defi ned.
When the contact input is activated, the
message is sent to the audio outputs.
Unlike the previous confi guration, it is not
necessary to activate the priority of the
audio input.
• Input: The input number where the
message generating source has been
connected must be entered using the
numeric keypad.
Press MENU/OK to save the data.
• Outputs: Enter the name of the output
or group of outputs to which the message
is to be sent. To add other outputs or
groups, press key
of the output or group that you wish
to add (maximum 100 outputs and/or
groups).
Press MENU/OK to save the data.
• Priority Level: The priority level is
established in the same way as when an
audio input is confi gured.
There are 64 different priority levels.
Maximum priority = 0
Minimum priority = 63
70
UMX-02/0
5
and then the name
5
and then the name
By default a priority of 5 is established.
• Gong: This option is for confi guration of
the gong (provided that the audio input
belongs to a UMX-EGC card).
- Off: This deactivates
announcement.
- Tones: This activates the gong of the
card.
- Personal: This
personalized pre-announcement.
must be recorded beforehand. Use of
the personalized pre-announcement is
incompatible with the use of queues and
pre-recorded messages on a card (RP1).
Situate the position indicators on the
desired option and press key
select.
The √ sign indicates
confi guration.
Press the MENU/OK key to save the
data.
These confi gurations do not modify the
confi guration of the audio input.
These confi gurations do not modify the
confi guration of the audio input.
4. PC Notifi cation
Through this function the control computer
is notifi ed of any variation in the status of
the contact.
For this purpose, the UMX-02/0 and the PC
must be connected by means of the RS485
bus.
5. Inc/Dec Volume
Enter the number corresponding to the
outputs or groups whose volume it is wished
to modify when the contact input is turned
off. These outputs will adopt the volume
defi ned when confi guring the increase /
decrease in volume of the audio outputs.
the pre-
activates the
This
5
to
the current
UMX-02/0 v1.0