Cleaning And Maintenance - HQ-Power VDPLP46B Manual Del Usuario

DIP switch
Value
• Each unit occupies 4 DMX channels. The functions are described below:
e. DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDPLP46B. Multiple VDPLP46Bs can be linked through serial linking. The linking cable should
be a two-core screened cable with XLR input and output connectors.
f. DMX512 Chain with Termination
g. Projector DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPLP46B.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPLP46Bs will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 4-channel VDPLP46B, you will have to set the start address of the first VDPLP46B to 1, the
second VDPLP46B to 5 (1 + 4), the third to 9 (5 + 4) and so on.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts apart from the fuse.
8. Contact your dealer for spare parts if necessary.
VDPLP46B
1.ON 2.ON 3.ON
1 2
DMX channel Function
Channel 1 Strobe 1-127, dimmer 128-255
Channel 2 0 – 100% dimmer RED
Channel 3 0 – 100% dimmer GREEN
Channel 4 0 – 100% dimmer BLUE
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
4.ON 5.ON
4 8 16
6
6.ON 7.ON 8.ON
32 64 128
9.ON
256
HQ POWER