Safety - Euronda EUROSEAL 2001 PLUS Manual De Instrucciones

EUROSEAL ® 2001 PLUS
Before using your electronic thermosealing machine EUROSEAL
please read carefully this safety information. Your lack of observance could
cause accidents or damage to the machine.
NEVER PLACE YOUR FINGERS NEAR THE SEALING AREA WHEN
THE MACHINE IS OPERATING
NEVER PLACE YOUR HANDS UNDER THE SEALER WHEN YOU
WARNING
PRESS THE SEALING LEVER
NEVER PLACE YOUR HANDS NEAR THE SHARP EDGE OF THE CUT-
TING BLADE.
KEEP THE MACHINE IN A CLEAN AND DRY AREA.
NEVER DISMANTLE THE Euroseal
INTERNAL VOLTAGE IS DANGEROUS
If it is not possible to disconnect the electricity or if it is too far or not visible to
the person who is making the repairs, attach the sign "Work in Process" on
the switch after having turned it "OFF".
CLEAN THE MACHINE WITH A DAMP CLOTH, AFTER ENSURING
THAT THE CONNECTION CABLE HAS BEEN UNPLUGGED
WARNING
(before reusing the machine make sure that the machine
is completely dry).
MAKE SURE THAT THE WIRING HAS A GROUND CABLE WHICH
CONFORMS TO ALL OF THE SAFETY NORMS OF THE COUNTRY OF
INSTALLATION.
NEVER REMOVE THE LABEL ON THE MACHINE
ENSURE THAT THE MACHINE IS CONNECTED TO THE CORRECT
ELECTRICAL VOLTAGE
USE EXCLUSIVELY THE ORIGINAL REFILLS
If the machine doesn't WORK properly refer to the selection in the manual "Solution to Problems"
for the possible cause. If you need subsequent information or the machine have to be repaired
contact the specialised personnel of the supplier or the technical office of Euronda S.p.A.

SAFETY

2001 PLUS. THE HIGH
®
® 2001 PLUS,
7