Ibiza Light BEE40-LED Manual De Instrucciones página 3

Features
Rotating bee effect moving head that scans the premises with bright, dynamic beams. The lens is adjustable to rotate
endlessly in 2 directions to create a graphic effect or come together to one single bright beam.
4 or 16 DMX channels
•
Auto, DMX, master-slave or sound control
•
• 8 built-in programs, with sound control in DMX mode
• Scan position memory
• 3-color wheel (red, yellow and blue) + open white, rainbow effect
Narrow beam 5°
•
• Linear dimmer 0-100%
Specifications
Power supply ........................................................................................ 100-240Vac 50/60Hz
Consumption .................................................................................................................. 55W
Light source .............................................................................................. 4x white 10W LED
Pan/Tilt .......................................................................................... 540°/190° 2 speed levels
Strobe ......................................................................................................................... 0-23Hz
Dimensions ............................................................................................ 245 x 145 x 330mm
Weight ......................................................................................................................... 4.06kg
Mounting
ORIENTATION
This fixture may be mounted in any position
provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of
the base, the included 'omega bracket' and the
safety cable rigging point in one unit (see the
illustration on the right).When mounting this
fixture on a truss, be sure to use an appropriate
clamp with the included omega bracket using a
M10 screw fitted through the center hole of the
'omega bracket'. As an added safety measure, be
sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable
rigging points integrated in the base assembly.
SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 100 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 16 fixtures
©Copyright LOTRONIC 2018 BEE40-LED Page 3