Oil Change - TRAPP BIO 300 s Manual De Instrucciones

Attention!
Before making any connections, make sure
the power supply is disconnected.
1. Make sure the power source where the
shredder will be installed is compatible
with the data on the motor plate.
2. Disconnect the power supply for motor
connections.
3. Make the connections shown according to
the power supply voltage.
4. To secure the connection, use duct tape on
connections made.
5. Make sure the connections are well
insulated.
6. Connect the power supply and check the
direction of rotation of the motor.
Make sure the engine is stocked with regular

gasoline in the tank and oil in the crankcase.
Check if the belt is not tensioned, place the on /

off button in the "ON" position and open the fuel
valve. Operate the choke lever, accelerate the motor
slightly and pull the lever of the retractable starter
until the motor runs.
To change motor oil
Establish the temperature range foreseen before
next change of oil. All oils must correspond to API
SG-SL classification.
1. Equipment must be on a flat and level surface.
2. Hot oil will drain better.
50
Connecting the Gasoline Motor

Oil Change

Gasoline
Gasoline engines leave the factory without oil or

gasoline. Before switching them on, check the oil
level and fill it in in the crankcase and fill the gasoline
in the fuel tank.
Avoid using gasoline left unused for more than 7

days to avoid engine malfunction.
Fill the tank with care to avoid spilling fuel.

Fill it up only with regular (not premium) gas.

Pay attention to the total amount of oil and gasoline

according to the engine model, for this check the
engine manual.
Gas tank capacity: 6,5 liters (15 HP TRAPP / Lifan

Engine) and 7 liters (13,5 HP Briggs & Stratton
Engine).
Note: for further information on operation, refer to the
engine manual.
Once the motor turns on and warms up, return the

choke lever to the initial position, accelerate the
motor until it reaches the ideal working rotation and
have the belts tensioned as indicated on page 54.
To shut down the engine in an emergency, turn off

the power switch. To shut it down in a regular work
situation, close the fuel valve and wait for the engine
to shut down until all fuel is consumed, then turn if
off on the On/Off switch.
3. Collect used oil in proper container.
4. Carefully unscrew oil container (1) to prevent
accidents such as burns.
www.trapp.com.br