TRAPP BIO 300 s Manual De Instrucciones página 52

Checks
Before starting the operation of the shredder
check the following:
If there are no tools or objects on the motor or

equipment, especially in the feeding funnel.
If there is nothing obstructing the motor and blade.

If the direction of rotation is correct.

If the line voltage corresponds to the shredder.

If there are people or objects near pulleys and

belts.
Attention!
Read all instructions in this manual before
using the machine, always observing
the safety instructions and following the
instructions to prevent accidents and/or
injuries.
The equipment must be installed on a solid and level

surface.
To mount the carrying handle proceed as shown in

Figure 3: Remove the carrying handle (5) from the
packaging and position it in its place. Mount the
bolt (1) the ferrule (2 and 3) and the screw (4). Do
the same on both cables and tighten as necessary,
as indicated in the torque table.
52
Operating Instructions
Using the Shredder
Figure 3



Note:
If the equipment is properly prepared,

start the motor. Wait until it reaches its
maximum rotation and start working.
For diesel or gasoline motors, keep

running for a few minutes to acquire
the normal working temperature.
Never start or stop operating a

combustion engine in a confined or
unventilated environment. Exhaust
fumes contain carbon monoxide, an
odorless and deadly gas.
1 2
Image merely illustrative
In the upper feed funnel (Item 2 Figure 3) can be
placed only branches with a maximum diameter Ø
3.0 cm. Materials from 3 cm up to 8 cm in diameter
should be crushed in the side feed hopper (item 1
Figure 3).
All BIO 300 crushers feature a knife, mounted
laterally on the cutting disc, to cut materials placed
on the side feed hopper.
The combination of the side blade with the side
funnel feeder allows to be crushed branches with a
maximum Ø 8 cm, which can be mixed with garden
waste and leftover food.
www.trapp.com.br
5
3 4